Show Ip Dhcp Snooping Binding; Switch Cluster Commands; Cluster - TP-Link TL-SL5428 User Manual

show ip dhcp snooping binding

This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
Console#show ip dhcp snooping binding
MacAddress
----------------- --------------- ---------- -------------------- ---- ---------
11-22-33-44-55-66 192.168.0.99
Console#

Switch Cluster Commands

Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. A switch cluster has a "Commander" unit that is
used to manage all other "Member" switches in the cluster. The management station
uses Telnet to communicate directly with the Commander throught its IP address,
and the Commander manages Member switches using cluster "internal" IP
addresses. There can be up to 36 Member switches in one cluster. Cluster switches
are limited to within a single IP subnet.
Command

cluster

cluster commander
cluster ip-pool
cluster member
rcommand
show cluster
show cluster members
show cluster candidates Displays current cluster Candidates in the network
cluster
This command enables clustering on the switch. Use the no form to disable
clustering.
Syntax
[no] cluster
Default Setting
Enabled
Command Mode
Global Configuration
IpAddress Lease(sec) Type
Table 4-40 Switch Cluster Commands
Function
Configures clustering on the switch
Configures the switch as a cluster Commander
Sets the cluster IP address pool for Members
Sets Candidate switches as cluster members
Provides configuration access to Member switches
Displays the switch clustering status
Displays current cluster Members
Switch Cluster Commands
0 Static
4
VLAN Interface
1 Eth 1/5
Mode Page
GC 4-324
GC 4-325
GC 4-326
GC 4-326
GC 4-327
PE 4-327
PE 4-328
PE 4-328
4-323