Resetting The System; Figure 3-20 Resetting The System - TP-Link TL-SL5428 User Manual

CLI – Enter the host ip address, followed by the mail severity level, source and
destination email addresses and enter the sendmail command to complete the
action. Use the show logging command to display SMTP information.
Console(config)#logging sendmail host 192.168.1.19
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
bill@this-company.com
Console(config)#logging sendmail destination-email
ted@this-company.com
Console(config)#logging sendmail
Console#

Resetting the System

This feature restarts the system. You can reboot the system immediately, or you can
configure the switch to reset after a specified amount of time.
Command Attributes
• Hours – Specifies the amount of hours to wait, combined with the minutes, before
the switch resets. (Range: 0-576; Default: 0)
• Minutes – Specifies the amount of minutes to wait, combined with the hours,
before the switch resets. (Range: 1-34560; Default: 0)
• Reset – Resets the switch after the specified time. If the hour and minute fields are
blank, then the switch will reset immediately.
• Refresh – Refreshes the countdown timer of a pending delayed reset.
• Cancel – Cancels a pending delayed reset.
Web – Click System, Reset. Enter the amount of time the switch should wait before
rebooting. Click the Reset button to reboot the switch or click the Cancel button to
cancel a configured reset. If prompted, confirm that you want reset the switch or
cancel a configured reset.

Figure 3-20 Resetting the System

Basic Configuration
3-33
3