Connect To Camera - Canon VB-C300 Administrator's Manual

Register Camera Server
●

Connect to Camera

Enter the user name and password to connect to the Camera Server. Enter the user
2
name in User Name and password in Password.
The settings are then saved to the Storage Server.
Note
Click Connect.
3
Once the Viewer has connected with the Camera Server, a tab is shown next to the
Add Camera Server dialog.
Note
94
Use the user name and password configured on the Camera
Server. If the user name and password are not sure, ask for
the System Administrator of the Camera Server.
Storage servers and VK viewers do not support IPv6.
You must click Connect before clicking OK to close the dialog
(the OK button is disabled until you do so).
When two or more cameras are used with VB150 (when "Video
Input" is set to "Single"), two through four tabs are added. The
number of tabs shown for a VB150 does not indicate the
physical number of cameras connected, but indicates the
number of cameras which have been enabled using the VB150
Camera and Video Settings Page. Please refer to Chapter 3, P. 36
of the VB150 User's Manual for more details.
If "Video Input" is set to "Single" for VB150, the camera name
displayed as the Camera Server Name is the first camera name in
the server's camera name list when "Use Camera" is selected on
the Camera and Video Settings Page. Therefore, it is recommended
that the Administrator should set the first camera name to be a
general name, applicable to the entire Camera Server.
If you are using a VB150 with the "Settings Web page URL" other
than the default setting "admin", a connection error occurs when
you click Connect. Restore the default setting and try again.
Enter the Host Name or IP address
1
in Host Name or IP, then enter the
port number for the Camera Server
in Port.
The Host Name or IP should be
255 characters or less (each label,
separated by a period, must be 63
characters or less), the IP address
must be 15 characters or less
(each label, separated by a period,
must be 3 characters or less), and
the Port must be a figure within
the range from 1 to 65535.