Table of Contents
Advertisement
(First display)
READY
WALK TEST
USER SETTING
INSTALLER MODE
ENTER CODE
[installer code]
1. NEW INSTL CODE
2. ENROLLING
3. DEFINE ZONES
4. DEFINE PANEL
5. DEFINE COMM
9. DEFINE CUSTOM
10. DIAGNOSTICS
11. USER SETTINGS
12. FACTORY DEFLT
13. SERIAL NUMBER
14. START UL/DL
<OK> TO EXIT
4.15 WALK-TEST
This mode (see Figure 4.1a) provides you with the means to conduct a periodic test, via the walk-test menu, at least once a
week and after an alarm event.
5. TESTING PROCEDURES
5.1 Preparations
Make sure all windows and doors are closed. If all zones
are secured (undisturbed), the display should read:
R E A D Y
If the display is "NOT READY", query the control panel by
pressing the
button repeatedly. The source(s) of the
I
OK
problem(s) will be displayed and read aloud. Take the
necessary measures to eliminate the problem(s) before
testing the system (see next paragraph).
5.2 Diagnostic Test
To verify proper function of all detectors in the system, a
comprehensive diagnostic test is required. To perform this
test, refer to figure 4.10.
5.3 Keyfob Transmitter Test
Initiate transmission from each transmitter enrolled as a
keyfob unit (according to the list in Table A2, Appendix A).
Use each transmitter to arm the control panel AWAY and
immediately disarm it. Upon pressing the keyfob unit's
AWAY key, the ARM indicator should light.
The display should respond as follows:
28
Displayed during
dialing process
Displayed during
download process
Download
Displayed for half
a minute approx.
accompanied by happy
(success) melody
Figure 4.14 – Start UL/DL
H H : M M
If UL/DL server
tel. # is already
defined (see
par. 4.5.34)
COMMUNICATING
Dialing
OK
DOWNLOADING
OK
DOWNLOAD OK
DOWNLOAD FAILED
The exit delay beeps will begin.
Press the keyfob unit's DISARM ( ) key. The ARM indicator
should extinguish, the announcement "Disarm, ready to arm"
should be heard and the display should revert to:
Test the AUX button in each keyfob in accordance with the
information noted in Table A2, Appendix A. Verify that the
AUX button performs its duty as programmed.
If the AUX ( ) button is defined as "INSTANT", press
the AWAY button and then the AUX button. The
response should be:
and the exit delay beeps will start. Press the DISARM
(
) key immediately to disarm.
If UL/DL server
tel. # was not
defined before
(see par. 4.5.34)
TEL # NOT DEFINED
accompanied by sad
Dialing
failed
DIAL ATTEMPT FAIL
accompanied by sad
Download
failed
accompanied by sad
A R M I N G A W A Y
P L E A S E E X I T N O W
R E A D Y
H H : M M
A R M I N G I N S T A N T
(alternating)
P L E A S E E X I T N O W
Displayed for half
a minute approx.
(failure) melody
Displayed for half
a minute approx.
(failure) melody
Displayed for half
a minute approx.
(failure) melody
D-302989
Advertisement
Table of Contents
