Access - Ricoh Aficio MP W3600 Network Manual

Monitoring and Configuring the Printer

access

Use the "access" command to view and configure access control. You can also
specify two or more access ranges.
❖ View settings
msh> access
2
❖ IPv4 Configuration
msh> access
• The star mark represents a target number between 1 and 5. (Up to five access
ranges can be registered and selected.)
Example: to specify accessible IPv4 addresses between 192.168.0.10 and 192.
168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
❖ IPv6 Configuration
msh> access
• The star mark represents a target number between 1 and 5. (Up to five access
ranges can be registered and selected.)
Example: to specify accessible IPv6 addresses between 2001:DB8::100 and
2001:DB8::200.
msh> access 1 range6 2001:DB8::100 2001:DB8::200
❖ IPv6 access mask Configuration
msh> access
• The star mark represents a target number between 1 and 5. (Up to five access
ranges can be registered and selected.)
Example: to specify accessible IPv6 addresses to 2001:DB8::/32
msh> access 1 mask6 2001:DB8:: 32
❖ Access control initialization
msh> access flush
• Use the "flush" command to restore the default settings so that all access
ranges become "0.0.0.0" for IPv4, and "::" for IPv6.
Note
❒ The access range restricts computers from use of the machine by IP address. If you
do not need to restrict printing, make the setting "0.0.0.0" for IPv4, and "::" for IPv6.
❒ Valid ranges must be from lower (start address) to higher (end address).
❒ If you are running IPv4 or IPv6, up to five access ranges can be registered and selected.
❒ IPv6 can register and select the range and the mask for each access ranges.
❒ IPv6 mask ranges between 1 - 128 can be selected.
❒ Up to five access ranges can be specified. The entry is invalid if the target number
is omitted.
❒ You cannot send print jobs, or access Web Image Monitor and diprint from a
restricted IP address.
62
range "start-address end-address"
range6 "start-address end-address"
mask6 "base-address prefixlen"