Ricoh Aficio MP W3600 Network Manual page 98

Monitoring and Configuring the Printer
keyphrase [ "phrase" ] val [1|2|3|4] You can specify the WEP key when entering in ASCII.
2
encval [1|2|3|4]
wepauth [open|shared]
rate [auto|11m|5.5m|2m|1m]
security {none|wep|wpa}
wpaenc {tkip|ccmp}
wpaauth {wpapsk|wpa|wpa2psk
|wpa2}
psk "character string"
90
Parameter Value configured
With a 64-bit WEP, you can use 10 digit hexadecimals.
With a 128-bit WEP, you can use 26 digit hexadecimals.
Up to four WEP keys can be registered. Specify the
number to be registered with "val".
When a WEP is specified by key phrase, the WEP
specified by key is overwritten.
To use this function, set the same key number and
WEP key for all ports that transmit data to each other.
You can omit the numbers with "val". The key number
is set to 1 when making these omissions. The default is
blank.
You can specify which of the four WEP keys is used for
packet encoding. "1" is set if a number is not specified.
You can set an authorization mode when using WEP.
The specified value and authorized mode are as follows:
open: open system authorized (default)
shared: shared key authorized rate
You can set the IEEE 802.11b transmitting speed.
The speed you specify here is the speed at which data
is sent. You can receive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
You can specify the security mode.
none: No encryption (default)
wep: WEP encryption
wpa: WPA encryption
You can specify WPA encryption key when using WPA
encryption.
tkip: TKIP
ccmp: CCMP (AES) (default)
You can specify the WPA authentication mode when
using WPA encryption.
wpapsk: WPA-PSK authentication (default)
wpa: WPA authentication
wpa2psk: WPA2-PSK authentication
wpa2: WPA2 authentication
You can specify the Pre-Shared key.
Usable characters: ASCII 0x20-0x7e (8 to 63 bytes).
The default is blank.