Advertisement
Available languages
Available languages
prompts to complete the installation. If you are asked for the location of your CD-
ROM drive, type the letter of your CD-ROM drive and a colon (D: if your drive
letter is D).
If you have Windows Me:
Turn your computer on. After you see a message that your new modem has been
detected and installed, insert your Installation CD-ROM into your CD-ROM drive.
Click Start, select Settings, then click Control Panel. Click View all Control Panel
Options in the upper-left corner of your screen. Double-click the System icon.
Click Device Manager. Expand Modems by clicking +. Double-click the
description of your new modem, then click the Driver tab. Click Update Driver.
Select Specify the location of the driver (Advanced). Click Next. Select
Removable media. Click Next. Select U.S. Robotics 56K Message V.92. Click
Next. Click Finish to complete the installation. Click Close on the U.S. Robotics
56K Message V.92 screen. Windows will now detect the Wave Device for Voice
Modem. Select Specify the location of the driver (Advanced). Click Next. Select
Removable media. Click Next. Select U.S. Robotics Half-Duplex Audio Device.
Click Next. Click Finish to complete the installation.
If you have Windows NT:
Windows NT users must be in administrator mode to properly add any
new hardware.
Turn your computer on. Insert your Installation CD-ROM into your CD-ROM drive
before you log in. Click Start, point to Settings, and click Control Panel. Double-
click Modems. When the Install New Modem screen appears, click Next to have
Windows detect your new modem. When your modem is detected, click Change.
Click Have Disk. Make sure the location of your CD-ROM drive is selected. Click
OK. Select U.S. Robotics. Select U.S. Robotics 56K Message V.92 (non-PnP).
Click OK and then Next. Click Finish. The Modems Properties tab will display the
COM port that is assigned to your modem. Click Close. If the System Settings
Change window appears, click Yes to restart your computer.
If you have Windows 2000:
Windows 2000 users must be in administrator mode to properly add any
new hardware. Your modem will be automatically installed. Follow the
update driver procedure below.
Turn your computer on. After you see a message that your new modem has been
installed, insert your Installation CD-ROM into your CD-ROM drive. Click Start,
select Settings, then click Control Panel. Double-click the System icon. Click the
Hardware tab. Click Device Manager. Expand Modems by clicking +. Double-
2
Advertisement
