Using Hold And Resume - Cisco 7942G Phone Manual

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
in the call information area and the corresponding line button flashes green
when you place a call on hold, the line button flashes green and the phone displays the hold icon. When
another phone places a call on hold, the line button flashes red and the phone displays the remote hold
icon.
If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts back to
ringing after a certain period of time. The 'reverting' call remains on hold until you resume it or until
Hold Reversion times out.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a flashing amber line button
If you want to...
Put a call on hold
Remove a call from
hold on the current line
Remove a call from
hold on a different line
Tips
• Engaging the Hold feature typically generates music or a beeping tone.
• If you receive an alert for an incoming call and a reverting call at the same time, by default your
phone will shift the focus of the phone screen to display the incoming call. Your system
administrator can change this focus priority setting.
• If you use a shared line, Hold Reversion rings only on the phone that put the call on hold, not on
the other phones that share the line.
22
Then...
1. Make sure the call you want to put on hold is highlighted.
2. Press Hold.
1. Make sure that the appropriate call is highlighted.
2. Press Resume.
1. Press the appropriate line button:
cause a held call to resume automatically:
• If there is a reverting call on the line, that call will resume.
• If there is more than one reverting call on the line, the oldest
reverting call will resume.
• If a non-reverting held call is the only call on the line, it will
resume.
2. If necessary, scroll to the appropriate call and press Resume.
next to the caller ID for the held call.
(depending on the line state).
or
appears on the right
. With a shared line,
(flashing). Doing so might
OL-17709-01