Using Hold And Resume - Cisco SPA 303g User Manual

Using Hold and Resume

To put a call on hold, press the Flash button (Cisco SPA 301) or the Hold button/ Hold softkey
(Cisco SPA 303). A series of beeps or music on hold (depending on the system configuration)
plays for the caller to indicate that the call is on hold. On the Cisco SPA 303, the phone LCD
shows a flashing right arrow indicating the line is on hold, as shown in the figure below.
To resume a call:
Press the flashing red line button for the call or the Hold button or the Resume sofkey. If you have
multiple calls, all calls are put on hold except the active call.
If you are on a call and another call comes in:
Do one of the following:
Press the Answer or Ignore softkey.
•
Press the Hold button/Hold softkey to place the call on hold and press the flashing red
•
line button to answer the incoming call.
To resume the first call, press the flashing red line button or the Hold button or the
•
Resume softkey.
38