Modulation Source Parameters • Changing The Default - Lexicon PCM 90 - REV 1 User Manual

PCM 90 User Guide
2-36
Turn ADJUST one click counterclockwise to display the default Destination
value (FLAT) assigned to High Cut when LFO1 is at its maximum value (127).
That's all there is to setting up a default patch— select a Source and Destination,
and the minimum and maximum patch values are set automatically.
Of course, you will often want to modify the patch further, either by adjusting the
modulation source parameters, changing the default values or adding additional
pivot points. In the following sections, we'll continue using this patch to
demonstrate examples of these modifications. When we're done, the new patch
will add dynamic spatialization to the Deep Blue program.
Adjusting the modulation source parameters
Continuing the previous example, we'll adjust the rate of LFO1 by jumping to it
from the Patch row.
Press Load/ repeatedly to return to the Patch 2 Source selection display.
Patch 2
Press Edit to jump directly to the LFO1 parameters in the Mod row.
The asterisk ( ) indicates that LFO1 Rate will be altered when
you turn ADJUST. Press Load / to change the selection to
the other LFO1 parameters ( Shape, P Width and Depth).
The display now shows position 5.0 in the Edit matrix Mod Row.
Turn ADJUST to change the rate of LFO1 to 0.30Hz.
Mod : LFO1
5.0
Now, press Edit to jump back to your previous position in the Patch row.
Patch 2
Int
Patch 2 Values
127 FLAT
Src
Int LFO1
Mod : LFO1 Rate
5.0 0.00 Hz
Rate
0.30 Hz
Src
LFO1
Lexicon