Bulk Data Dumps - Lexicon PCM 90 - REV 1 User Manual

PCM 90 User Guide

Bulk Data Dumps

5-8
Dynamic MIDI
The following MIDI messages are available as Dynamic MIDI patch sources:
MIDI Controllers 1-31 and 33-119
Pitch Bend
After Touch (Polyphonic and Channel combined)
Velocity (Note On)
Last Note
Low Note
High Note
Tempo (40–400BPM is converted to controller range 0-127)
Clock Commands
These MIDI messages are also available as threshold sources for several
Modulation parameters: AR Env, Latch, Sw 1 and Sw 2, and S&Hold. They may
also be used as a tap source for controlling Tempo.
MIDI Implementation Details, including System Exclusive documentation, are
available to assist experienced programmers in developing software for use
with the PCM 90. These can be obtained directly from Lexicon.
Request: PCM 90 MIDI Implementation Details.
Control mode 3.8 (MIDI Dump) allows selection of the following types of bulk
data to be dumped directly from the PCM 90 to another PCM 90, or to editor/
librarian software.
Displayed Name
CurrentPgm
Bank R0-R1
Bank C0-CJ
Map 0, 1
Map 2-3
Chain 0-9
Chain 10-19
Int Chains
Ext Chains
Setup C
Setup 0-4
Setup 5-9
Use ADJUST to select the bulk data type. Press Store to transmit the data .
Description
Currently running effect
Internal Register Banks
Card Banks (card must be inserted)
Internal Program Change Maps
Card Program Change Maps (card must be inserted)
Internal Program Chains
Card Program Chains (card must be inserted)
All Internal Program Chains
All Card Program Chains (card must be inserted)
Current Setup
Internal Setups
Card Setups
Lexicon