Lexicon PCM 90 - REV 1 User Manual page 53

Turn SELECT to select Patch 2 (which is set to Off).
Patch 2
Turning ADJUST will scroll through the entire list of available patch Sources.
Turn ADJUST counterclockwise until LFO1 is displayed in the lower right.
Patch 2
LFO1 is now assigned as a patch Source.
Press Load/ to bring up patch Destinations for selection. The display should
show that Destination is unassigned.
The ADJUST knob will now scroll through all of the available parameters of Deep
Blue. The lower line of the display will show the edit matrix row label on the left,
and the parameters in that row on the right.
Turn ADJUST clockwise until High Cut (in the effect's Design row) is displayed
in the lower right corner of the display.
The High Cut parameter is now assigned as the patch Destination.
Now, press Load/ to bring up the Values display. This will show the default
Destination value setting (0.1kHz). This is the value assigned to High Cut when
LFO1 is at its minimum value (000).
Src
Int Off
Src
Int LFO1
Patch 2 Dst
Unassigned
Patch 2 Dst
Design High Cut
Patch 2 Values
000 0.1kHz
Basic Operation
2-35