Lexicon PCM 90 - REV 1 User Manual page 31

Map
Program Change 0-127 can be mapped to any PCM 90 effect in any internal or
card bank. Two 128 element maps are stored internally, additional maps may be
stored on RAM cards. Once you have selected Map, press Load/ to display:
MIDI Pgm Change
3.3
Turn ADJUST to select the desired Program Change Map.
Chain
Any Program Change number can be selected to load any one of ten customized
effect "chains". Additional chains can be stored on RAM cards. Once a chain is
loaded, effects in the chain are accessed by the controller patched to Pgm + and
Pgm – (program increment and program decrement). Once you have selected
Chain, press Load/ to display:
MIDI Pgm Change
3.3
Turn ADJUST to select the desired Program Chain. When set to MIDI, Program
Chains will be loaded by MIDI Program Change messages according to the
settings of Chain Pgm Assign in Row 6.
To load a specific Program Chain, without sending the PCM 90 a MIDI Program
Change message, use ADJUST to display the desired chain number.
MIDI Pgm Change
3.3
3.4 Automation
This control is provided to allow one PCM 90 to act as a master for any number
of slaved PCM 90s. Select On to have values resulting from front panel
operations sent out as SysEx messages. Press Load/
or All) of the target PCM 90(s).
3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST, Custom 1-4)
If Transmit is set to On these controls can transmit MIDI controller messages.
Press Load/ to cycle through the controller selections. Use ADJUST to select
the MIDI Controller message to transmit. Receipt of MIDI Controller messages
will affect the PCM 90 in the same manner as if the internal controls were
adjusted.
3.6 Int Clock
You can choose to have the PCM 90 transmit MIDI Clock at the current tempo
rate by setting this control to On and Tempo mode Source (0.2) to Internal. If
this control is set to Off, MIDI Clock will not be transmitted.
MapSelect 0
Chain MIDI
Chain 3
to select the ID (0-126
Basic Operation
2-13