Mod Row Patches - Lexicon PCM 90 - REV 1 User Manual

PCM 90 User Guide Lexicon
Multiple Patches with the Same Destination
If you create two or more patches with the same Destination, the Destination
value will be the sum of all of the patches assigned to it.
For example, if Footpedal and ADJUST are both assigned to Mix, the Mix value
will be the sum of the patch Destination values for those two patches. When
creating multiple patches to the same Destination, you should set the individual
Destinations to values which, when added together, are less than or equal to the
maximum value for the parameter. Footpedal and ADJUST, for example, could
each have a maximum value of 50%, or they could be assigned values of 25%
and 75%, 60% and 40%, etc.
When the sum of multiple patched parameter Destination values is greater than
the maximum value of the parameter, the parameter value will remain at
maximum until the sum of the patches falls below it.

Mod Row Patches

AR ENV, Latch, Sw 1, Sw 2 , Delay and S&Hold are each activated by
assigning a threshold source to T Src that is used to turn them on and off. This
assignment is a subparameter in the Mod row — not in the Patch row.
2-40