Custom (4.0-4.9) - Lexicon PCM 90 - REV 1 User Manual

PCM 90 User Guide
P4 Splits cont'd.
4-26
4.0 Thunder&Ice
KeyWords: Splits Special FX, Spatial, Custom
Two completely opposite reverbs at your disposal. Use ADJUST to blend or separate the
short, bright Room and the big and thunderous Chamber. For a backwards effect, go to
Custom 1. To change the In Routing configuration, use Custom 2. Custom Controls 3 and
4 are dynamic effects:a switch ramping the Mix from Wet to Dry, with the controller
accessing the speed of the ramp, and an LFO patched to the High Cut of the Room (Ice)
setting — you can control the rate of oscillation.
Custom 1: Inverse Effects
Custom 2: In Routing
Custom 3: Wet to Dry Ramp
Custom 4: Im-Pulse Ice
4.1 Ring Verb
KeyWords: Splits, Special FX, Spatial, Custom
This Chamber/Hall preset lets you have a long, bright reverb and an ultra-metallic ring
mod. ADJUST lets you blend or separate these two effects. Custom 1 tunes the frequency
of the ring mod. Custom 2 lets you change the In Routing status. Enhance your stereo
sound with Custom 3, or use Custom 4 to turn up some delay and then Tap in the delay
time or dial in the BPM.
Custom 1: Mod Tuner
Custom 2: In Routing
Custom 3: Stereo Enhancer
Custom 4: TapReflect Level
4.2 Dark & Brite
KeyWords: Splits, Special FX, Spatial, Custom
A dark, dense reverb and a bright, thin reverb. Use ADJUST to balance the two. Use the
Inverse EQ effect on Custom 1 to cut the highs on the Room while boosting them on the
Chamber. Custom 2 lets you change the effect from forwards to backwards, while Custom
3 adds a bit of Predelay to the signal. Custom 4 gives you a bit more EQ enhancement.
Custom 1: Inverse EQ
Custom 2: Inverse Effects
Custom 3: Pre Delay
Custom 4: Briteness Enhancer
4.3 Dark & Gated
KeyWords: Splits, Special FX, Custom, Gated
A dynamic effect with input level affecting the Shape setting of the Room, and triggering
the Infinite switch on the Chamber reverb. When Infinite triggers, then releases, a gate
effect is produced. Use ADJUST to change the Mode of the AR envelope. Use Custom
1 to change the release time of the gate. Custom 2 changes the balance of the Chamber/
Room levels, Custom 3 changes their Sizes. Input level also controls a Master Delay line
that is active at lower levels, then cuts out and the gate kicks in at higher levels. Use
Custom 4 to change the level of this delay.
Custom 1: Gate/Shape Release
Custom 2: Effects Blend
Custom 3: Switch the Sizes
Custom 4: Master Delay Level
4.4 Pipe Reverb
KeyWords: Splits, Special FX, Bright, Custom
With all the characteristics of a pipe in mind, this small drain to enormous tunnel reverb
is great as a special effect for television or film. Use ADJUST to choose pipe size, or just
use Custom 1 to control the basic Size settings. For more control over the EQ, use Custom
2 to change the high frequencies.
Custom 1: Size
Custom 2: High Cut
Custom
ADJUST: Effects Blend
ADJUST: Verb to Mod
ADJUST: Reverb Blend
ADJUST: Toggle Gate FX
ADJUST: PipeSize
Lexicon