Patching Examples - Lexicon PCM 90 - REV 1 User Manual

PCM 90 User Guide

Patching Examples

2-34
Jump
When creating patches, there are situations in which you will want to leave the
Patch row to adjust parameters. To make this convenient, a Jump command is
available. Jumping is dependent on the current Patch display, and is activated
simply by pressing Edit while a certain display is active. This will jump you out
of the Patch row and to the location where you can make the necessary
adjustments. Pressing Edit again will jump you back to the Patch Row. (Note
that using any front panel controls other than those required to adjust the
parameter to which you have jumped, will disable the jump. This is not
catastrophic, but it will require you to return by using Up and Down and
SELECT.) The following Jumps are available:
From the Patch row Src display:
• With ADJUST or Custom 1-4 selected as the Source, press Edit to jump to
the Controls row, where you can specify range limits. Press Edit again to
return to the Patch row.
• With any modulation parameter selected as a Source, press Edit to jump
to the Modulation row position of the Source. For example, if the Patch
source LFO is displayed, press Edit to jump to Modulation row position 0
(LFO) where you can edit any LFO parameter value. Press Edit again to
return to the Patch row.
From the Patch row Dst selection display:
• Press Edit to jump to the Edit controls for the parameter you have selected
as the Destination. You will have complete access to all parameter controls,
including any subparameters at that location. Press Edit again to return to
the Patch row.
From the Patch row Values display:
• Press Edit to jump to the next Src or Dst value. Default values are
0...minimum, 127...maximum.
The following examples illustrate how to create a patch, use the patch jump
features, modify the default patch values and add an additional pivot point to
the example patch values.
Creating a patch with default values
Load program P0 0.0 Deep Blue. Press Edit to enter Edit mode, then press
Up to move to the Patch Row. Press Load/ until the display looks like this:
Patch 0 Src
Int ADJUST
Lexicon