Lexicon 960L Owner's Manual page 39

960L
44.1/48KHZ CONFIGURATIONS
When the sample rate of the 960L is set to 44.1kHz or 48kHz
the following configurations are available.
THE FOUR MONO-IN CONFIGURATION
Figure 4-5 — 44.1/48kHz Mono-In/Stereo-Out
Configuration: four machines available
With the "Four Mono-In" configuration loaded, the DSP
card is partitioned into four independent Mono-In/Stereo-
Out machines. Each machine has an independent mono
input and independent stereo outputs. This configuration
is similar to the mono split configuration on the 480L.
Note:
If you desire mono outputs, you can map both
outputs of a machine to the same destination as
described in the section on output routing.
THE FOUR-CHANNEL CASCADE CONFIGURATION
Figure 4-6 — 44.1/48kHz Four-Channel Cascade
Configuration: two machines available
With the "4-In Cascade" configuration loaded, the DSP
card is partitioned into two independent, cascaded, four-
channel surround machines. Each machine has four
inputs and four outputs. The four outputs of the first
machine are fed directly into the four inputs of the second
machine. The four outputs of the first machine, as well as
being used as inputs to the second machine, can be rout-
ed to any physical output on the 960L.
In a cascaded configuration, the unpanned outputs of
the first machine are fed into the inputs of the second
machine at full level. That is why the second machine
does not show any controls on its input page.
THE FIVE-CHANNEL CASCADE CONFIGURATION
With the "5-In Cascade" configuration loaded, the DSP
card is partitioned into two independent, cascaded, five-
channel surround machines. Each machine has five inputs
and five outputs. The five outputs of the first machine are
fed directly into the five inputs of the second machine.
The five outputs of the first machine and the five outputs
of the second machine are combined. The output levels
of the five outputs of the first machine and the five outputs
of the second machine can be adjusted independently
using each machine's output page.
In a cascaded configuration, the unpanned outputs of
the first machine are fed into the inputs of the second
machine at full level. That is why the second machine
does not show any controls on its input page.
THE EIGHT-IN / EIGHT-OUT CONFIGURATION
With the "One 8-In/8-Out" configuration loaded, the DSP
c a rd is partitioned into one eight-input/eight-output
machine. Currently this configuration is used for diagnos-
tic purposes only.
Home Next Page >>
Figure 4-7 — 44.1/48kHz Five-Channel Cascade
Configuration: two machines available
Figure 4-8 — 44.1/48kHz 8-In/8-Out Configuration:
one machine available
<< Go Back
Operations in Detail
4-7