Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lexicon 960L V2.4 - INSTALLATION AND RELEASE NOTES REV 3
Summary of Contents for Lexicon 960L V2.4 - INSTALLATION AND RELEASE NOTES REV 3
- Page 1 960L Version 2.4 Software Upgrade Installation Instructions & Release Notes...
- Page 2 Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) This document should not be construed as a commitment on the part of Lexicon, Inc. The information it contains is subject to change without notice. Lexicon, Inc. assumes no responsibility for errors that may appear within this document.
-
Page 3: Installation Instructions
Installation Instructions & Release Notes 960L Version 2.4 Software This document contains installation instructions for the 960L Version 2.4 Software. It describes updated and enhanced features of Version 2.4, and discusses items that did not receive full coverage in the owner’s manual. Please refer to the 960L Owner’s Manual for additional information. - Page 4 Installation Instructions & Release Notes Lexicon 2. Press 1 to begin installation. A number of progress messages will appear. When this phase of installation is complete (after about one minute), the following message will appear: Install complete. Please remove CD from drive.
- Page 5 Installation Instructions & Release Notes 960L Version 2.4 Software 6. Enter the serial number again as it appears on the back panel of the 960L mainframe. Once again, do not enter the first letter of the serial number. Enter the numbers and the dash only. Press ENTER when finished and the system will start.
- Page 6 Installation Instructions & Release Notes Lexicon RELEASE NOTES The list below includes features of the 960L Software Version 2.4 that are not fully covered in the owner’s manual: • When configuring systems with two DSP cards, there are no longer two soft buttons labeled CONFIG 1 and CONFIG 2.
- Page 7 Installation Instructions & Release Notes 960L Version 2.4 Software • Manual fader adjustment may be prevented when the fader is automatically positioned near the top or bottom of its physical range, even if the parameter is not set to its maximum or minimum value.
- Page 8 A Harman International Company Lexicon, Inc. 3 Oak Park Bedford, MA 01730-1441 USA Tel 781-280-0300 Fax 781-280-0490 www.lexicon.com Customer Support Tel 781-280-0300 Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) Lexicon Part No. 070-14818 | Rev 3 | 07/01...
Need help?
Do you have a question about the 960L V2.4 - INSTALLATION AND RELEASE NOTES REV 3 and is the answer not in the manual?
Questions and answers