Scanning - General Information; Setting The Scan-Resure Technique - Yaesu VX-8R Operating Manual

50/144/430 mhz triple-band heavy duty submersible transceiver
Hide thumbs Also See for VX-8R:
Table of Contents

Advertisement

S
CANNING
The VX-8R allows you to scan just the memory channels, the entire operating band, or a
portion of that band. It will halt on signals encountered, so you can talk to the station(s) on
that frequency, if you like.
Scanning operation is basically the same in each of the above modes. Before you begin,
take a moment to select the way in which you would like the scanner to resume scanning
after it halts on a signal.
S
S
ETTING THE
CAN
Three options for the Scan-Resume mode are available:
2.0sec - 10.0sec: In this mode, the scanner will halt on a signal it encounters, and will
2.0sec - 10.0sec
2.0sec - 10.0sec
2.0sec - 10.0sec
2.0sec - 10.0sec
BUSY:
BUSY
BUSY
BUSY
BUSY
HOLD
HOLD
HOLD
HOLD:
HOLD
To set the Scan-Resume mode:
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 83: SCAN
RESUME
RESUME
RESUME.
RESUME
RESUME
3. Press the
key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select the desired scan-resume
mode.
5. Press the PTT switch to save the new setting and exit to
normal operation.
The default condition for this Set Mode Item is "5.0sec".
60
G
-R
T
ESUME
ECHNIQUE
hold there for the selected resume time. If you do not take action to
disable the scanner within that time period, the scanner will resume
even if the station is still active.
In this mode, the scanner will halt on a signal it encounters. When the
carrier has dropped because the other station ceased transmission, the
scanner will resume. In the case of constant-carrier signals like Weather
Station broadcasts, the scanner will likely remain on this frequency
indefinitely. The Scan Re-start Delay time (default interval: 2 seconds)
is set by Set Mode Item 82: SCAN RE-START
In this mode, the scanner will halt on a signal it encounters. It will not
restart automatically; you must manually re-initiate scanning if you
wish to resume.
key for one second to enter the Set Mode.
ENERAL
82: SCAN RE-START.
82: SCAN RE-START
82: SCAN RE-START
82: SCAN RE-START
83: SCAN
83: SCAN
83: SCAN
83: SCAN
VX-8R O
M
PERATING
ANUAL

Advertisement

Table of Contents
loading

Table of Contents