Table of Contents
Advertisement
A
CTIVATION
1. Press and hold the
2. Rotate the DIAL knob to select Set Mode Item 17:
BLUETOOTH SET
BLUETOOTH SET
BLUETOOTH SET
BLUETOOTH SET.
BLUETOOTH SET
3. Press the
key briefly to enable selection of this Set Mode
Item.
4. Rotate the DIAL knob to select the TX/RX switching cir-
cuit of the Bluetooth
VOX: OFF
VOX: OFF
VOX: OFF:
VOX: OFF
VOX: OFF
VOX: PTT:
VOX: PTT
VOX: PTT
VOX: PTT
VOX: PTT
VOX: VOX HIGH: Activates the Bluetooth
VOX: VOX HIGH
VOX: VOX HIGH
VOX: VOX HIGH
VOX: VOX HIGH
VOX: VOX LOW: Activates the Bluetooth
VOX: VOX LOW
VOX: VOX LOW
VOX: VOX LOW
VOX: VOX LOW
key, then rotate the DIAL knob to select the
5. Press the
Battery Saver function:
SAVE: ON: Activates the Battery Saver in the BH-1 ( or
SAVE: ON
SAVE: ON
SAVE: ON
SAVE: ON
BH-2 ) .
If there has been no signal or key activity for 20 seconds, the Battery
Saver automatically puts the BH-1 ( or BH-2 ) to "sleep", to conserve
battery life. When a signal is received or the PTT switch is pressed, the
BH-1 ( or BH-2 ) will wakeup and become active again.
Furthermore, if there has been no signal or key activity for 10 minutes,
the BH-1 ( or BH-2 ) will turn off automatically.
SAVE: OFF: Disable the Battery Saver in the BH-1 ( or BH-2 ) .
SAVE: OFF
SAVE: OFF
SAVE: OFF
SAVE: OFF
6. Press the
key, then rotate the DIAL knob to select the
receiver audio output mode of the Bluetooth
parameter is ignored when using the BH-2 Bluetooth
Headset):
MODE: STEREO: Outputs stereo receive audio while listening to the FM Broadcast
MODE: STEREO
MODE: STEREO
MODE: STEREO
MODE: STEREO
MODE: MONO: Outputs monaural receive audio while listening to the FM Broad-
MODE: MONO
MODE: MONO
MODE: MONO
MODE: MONO
7. If you wish to turn the Bluetooth
when you are not operating the Bluetooth
dures, otherwise, skip to next step.
VX-8R O
PERATING
key for one second to enter the Set Mode.
®
function:
Disable the TX/RX switching circuit of
®
the Bluetooth
function (RX only).
Activates the Bluetooth
Gain: High).
Gain: Low).
band.
Note: When this mode is selected, the VOX function does not work
even if the VOX function is selected in step 4. above. The TX/RX
switching is performed by pressing the PTT switch.
cast band.
®
M
ANUAL
Bluetooth
17:
17:
17:
17:
®
function for use with the PTT circuit.
®
function with the VOX feature (VOX
®
function with the VOX feature (VOX
®
unit (this
unit off to conserve transceiver battery power
®
function, perform the following proce-
O
®
PERATION
®
73
Advertisement
Table of Contents
