Table of Contents
Advertisement
DTMF S
ETTING
Selects the DTMF Autodialer Delay Time.
Enables/Disables the DTMF Autodial feature.
Programming the DTMF Autodialer.
Selects the DTMF Autodialer Sending Speed.
S
/K
S
WITCH
NOB
ETTING
Set the duration that a secondary function of the [ F/W ] key (press and holding the [ F/W ] key) is held
determines the function they activate.
Selects the function of the [ H/M ] key.
Selects the Control Locking lockout combination.
Selects the MONI key (just below the PTT switch) function.
Selects the time delay before the carrier is transmitted, when the PTT switch is pressed.
Select the [ VOL ] key function.
D
S
ISPLAY
ETTING
Indicates the DC Supply Voltage.
Selects the LCD/Keypad Lamp mode.
Setting the Display contrast level.
Setting the Display brightness level.
Illuminates the white LED light continuously (useful as emergency flashlight at night).
Selects the Opening Message that appears when the radio is powered on.
Selects the sensor information when the transceiver is operating in the "Mono" band mode with large
character.
Displays internal sensor information.
Selects the S- & TX PO meter Symbol.
Selects the Spectrum Analyzer sweep mode.
Calibrating the Sensor Unit.
Selects the measurement units of the Sensor Unit.
Selects the Wave-Form display while indicating the Wave-Form via Set Mode Item 84: SENSOR DISPLAY.
B
S
EEP
ETTING
Enables/Disables the Band-edge beeper while selecting the frequency with the DIAL knob.
Adjust the Beep volume level.
Create the Beep Melody for Bell ringer function.
Enables/Disables the keypad beeper.
Select the CW tone pitch for the CW Learning, CW Training, and CW Identifier functions.
M
S
ISCELLANEOUS
ETTING
Select the antenna to be used for the AM Broadcast listening.
Enables/Disables the receiver Front-end Attenuator.
Select the antenna to be used for the FM Broadcast listening.
Enables/Disables the Busy Channel Lock-Out feature.
Selects the Channel Counter Search Width.
Shifting of CPU clock frequency.
Enables/Disables the CW Learning feature.
Enables/Disables the CW Training feature.
Enables/Disables the extended Set Mode Menu.
Reducing the Deviation level by 50 %.
Enables/Disables the function of the VFO DIAL knob, while in the Home Channel mode.
Selects the language for the Set Mode selections.
Adjusts the microphone gain level.
Adjusts the receiver audio output level when the MUTE function was activated.
Set the OFF Timer time.
Set the ON Timer time.
Programming and activating the Password feature.
Select the resume mode of the AF-Dual Operation.
Sets the receiving mode.
Selects the Set Mode Cursor.
Selects the display format of the Set Mode operation.
Selects the Smart Search Sweep mode.
Enables/Disables the FM Broadcast audio output to the internal speaker when using the earphone antenna.
Sets the Squelch threshold level.
Adjusts the Squelch threshold level to the S-meter level.
Setting of the DIAL frequency steps.
Enables/Disables the stereo output while receiving the FM Broadcast band.
Sets the Clock time.
Setting of the TOT time
Selects or disables the VFO band edge limiting for the current band.
Set My Band.
Enables/Disables VOX operation; sets VOX sensitivity.
Selects the VOX delay ("hang") time.
Enables/Disables the Weather Alert Feature
VX-8R O
PERATING
M
ANUAL
S
M
I
A
ET
ODE
TEM
VAILABLE
28:
DTMF DELAY
50ms / 250ms / 450ms / 750ms / 1000ms
29:
DTMF MANUAL/AUTO
MANUAL / AUTO
30:
DTMF SELECT
--
31:
DTMF SPEED
50mS / 100mS
S
M
I
A
ET
ODE
TEM
VAILABLE
36:
FW KEY HOLD TIME
0.3sec / 0.5sec / 0.7sec / 1.0sec / 1.5sec
39:
HOME/REVERSE
HOME / REV
51:
LOCK
KEY / DIAL / KEY&DIAL / PTT / KEY&PTT /
DIAL&PTT / ALL
61:
MONI/T-CALL
MONI / T-CALL
73:
PTT DELAY
OFF / 20ms / 50ms / 100ms / 200ms
107:
VOLUME MODE
NORMAL / AUTO BACK
S
M
I
A
ET
ODE
TEM
VAILABLE
25:
DC VOLTAGE
--
46:
LAMP
KEY 2sec - KEY 10sec / CONTINUOUS /
OFF (KEY 5sec)
48:
LCD CONTRAST
LEVEL 1 ~ LEVEL32 (LEVEL24)
49:
LCD DIMMER
LEVEL 1 ~ LEVEL 4
50:
LED LIGHT
--
65:
OPENING MESSAGE
NORMAL / OFF / DC / MESSAGE
84:
SENSOR DISPLAY
DC / TEMP / WAVE / BARO / ALTI / WX / OFF
85:
SENSOR INFORMATION
--
89:
S-METER SYMBOL
Four patterns
91:
SPEC-ANALYZER
1Time / Continuous / Full Time
103:
UNIT OFFSET
BARO: -1000 ~ 0 ~ +1000,
ALTITUDE: -1000 ~ 0 ~ +1000
104:
UNIT SELECT
TEMP: °C / °F,
BARO: HPA / mb / mmHg / inch,
ALTITUDE: m / ft
110:
WAVE MONITOR
ALL / RX SIGNAL / TX MODULATION
S
M
I
A
ET
ODE
TEM
VAILABLE
10:
BEEP EDGE
ON / OFF
11:
BEEP LEVEL
LEVEL 1 - LEVEL 9 (LEVEL 5)
12:
BEEP MELODY
--
13:
BEEP SELECT
KEY & SCAN / KEY / OFF
23:
CW PITCH
400 - 1000 Hz (50 Hz/step) (700 Hz)
S
M
I
A
ET
ODE
TEM
VAILABLE
1:
ANTENNA AM
BAR & EXT / BAR ANTENNA
2:
ANTENNA ATT
ON / OFF
3:
ANTENNA FM
EXT ANTENNA / EARPHONE
9:
BCLO
ON / OFF
19:
CH COUNTER
±5 MHz / ±10 MHz / ±50 MHz / ±100 MHz
20:
CLOCK SHIFT
ON / OFF
22:
CW LEARNING
--
24:
CW TRAINING
--
35:
EXTENDED MENU
ON / OFF
37:
HALF DEVIATION
ON / OFF
38:
HOME VFO
DISABLE / ENABLE
47:
LANGUAGE
ENGLISH / JAPANESE
60:
MIC GAIN
LEVEL 1 ~ LEVEL 9 (LEVEL 5)
62:
MUTE
MUTE 30%,MUTE 50%, MUTE 100%, or OFF
63:
OFF TIMER
--
64:
ON TIMER
--
69:
PASSWORD
--
77:
RX AF DUAL
TRX 1sec ~ TRX 10sec /
HOLD / TX 1sec ~ TX 10sec (TRX 2sec)
78:
RX MODE
AUTO / NFM / AM / WFM
86:
SET MODE CSR
Nine patterns
87:
SET MODE FORMAT
LIST / ITEM
88:
SMART SEARCH
SINGLE / CONTINUOUS
90:
SPEAKER OUT
AUTO / SPEAKER
92:
SQL LEVEL
LEVEL 0 ~ LEVEL 15 (LEVEL 1)
LEVEL 0 ~ LEVEL 8 (LEVEL 2)
93:
SQL S-METER
OFF / LEVEL 0 ~ LEVEL 9
96:
STEP FREQUENCY
AUTO / 5.0 /6.25 / 8.33 / 9.0 / 10.0 / 12.5 / 15.0 /
20.0 / 25.0 / 50.0 / 100 kHz
97:
STEREO
STEREO / MONO
98:
TIME SET
--
102:
TOT
OFF / 0.5min ~ 10.0min (0.5min/step) (3.0min)
105:
VFO MODE
ALL / BAND
106:
VFO SKIP
--
108:
VOX
OFF / HIGH / LOW
109:
VOX DELAY
0.5sec / 1.0sec / 2.0sec
111:
WX ALERT
ON / OFF
S
M
ET
ODE
( D
)
V
: B
I
ALUES
EFAULT
OLD
TALIC
( D
)
V
: B
I
ALUES
EFAULT
OLD
TALIC
( D
)
V
: B
I
ALUES
EFAULT
OLD
TALIC
( D
)
V
: B
I
ALUES
EFAULT
OLD
TALIC
( D
)
V
: B
I
ALUES
EFAULT
OLD
TALIC
(AM and Narrow FM),
(Wide FM and AM Broadcast)
141
Advertisement
Table of Contents
