Simrad TRANSDUCER - INSTALLATION GENERIC REV H Installation Manual page 20

Simrad Echo sounder transducers
18
Example: Small transducer
The illustration below shows a typical transducer blister designed
for a small transducer. The same blister design principles as for a
large transducer apply.
E
(CD017010B)
(A) = Streamlined blister
(B) = Mounting ring
(C) = Clamping ring
(D) = Guide
Note that the transducer cable must be provided with a cable loop
inside the blister. Observe the vertical forward edge of the blister.
This will guide the water to each side of the blister.
E
B
G
C
(E) = Air outlet
(F) = Forward
(G) = Transducer cable
A
F
D
851-160164/H