Single Beam, High Power Transducer - Simrad TRANSDUCER - INSTALLATION GENERIC REV H Installation Manual

Single beam, high power transducer

Transducer
cable
Drain wire
Screen
W802-2
Rev.E
851-160164/H
This is the termination of the transducer cable from a single
frequency, single beam transducer to the transducer socket on the
General Purpose Transceiver Unit (GPT). The other end of the
cable is permanently fixed to the transducer.
High power output is achieved when the GPT is equipped with
four transmitter boards.
Junction Box (1:1)
(Optional)
Single frequency, single beam, high power termination
If you need to splice the transducer cable, it is very important to
use the correct cable, and to avoid ground loops. We strongly
recommend the use of a junction box. We also recommend that
you install the transducer cable in a steel conduit.
Related topics
Cable splicing on page 36
Steel conduit on page 37
GPT transducer terminations
GPT Transducer
A N
B
M
C
L
D K
E J
F H
Connect to plug housing
socket
A
B
C
D
E
F
H
J
53