Cable Gland For Wood Or Grp Hulls - Simrad TRANSDUCER - INSTALLATION GENERIC REV H Installation Manual

Simrad Echo sounder transducers

Cable gland for wood or GRP hulls

34
A bronze cable gland kit is available for wood and GRP vessels.
B
B
B
(A) = Packing nipple. Make sure that you do not damage the
transducer cable by tightening the packing nipple too hard!
(B) = Washers
(C) = Rubber gaskets
(D) = Hole diameter 28 mm
(E) = Steel conduit
(F) = Cable to the echo sounder (or a junction box)
The cable gland kit includes all of the necessary parts needed to
install the unit except screws.
Simrad recommends that a one inch steel conduit (that the
transducer cable will be run through) with an inside threaded
diameter of three-quarter inches is attached to the gland's packing
nipple. This connection must be watertight, and the conduit must
extend to above the vessel's water line.
A
C
C
C
F
E
D
(CD17008B)
851-160164/H