Simrad TRANSDUCER - INSTALLATION GENERIC REV H Installation Manual page 19

E
(CD017010A)
C
E
851-160164/H
Example: Large transducer
The illustration below shows a typical transducer blister designed
for a large transducer. Note that due to the physical size of
the transducer, a U-shaped support bar (E) is used to support
the transducer. The purpose of this support is to prevent the
transducer from being pushed up into the blister in heavy seas.
H
G
A
(A) = Streamlined blister
(B) = Stiffening rib
(C) = Drainage holes
(D) = Inclination angle
(E) = U-shaped support bar
(F) = Forward
Ways of mounting the transducer
I
D
B
F
(G) = Cable service loop
(H) = Stuffing tube
(I) = Minimum 400 mm
(J) = Rounded corners
(K) = Air outlet
K
J
17