User Hypermodel; Midi Mapping - DigiTech GNX3000 Owner's Manual

1. Connect a MIDI cable from the GNX3000 MIDI Out to the MIDI In of a MIDI
recording device.
2. Press the UTILITY button. The Utility button's LED will light.
3. Use the PREV or NEXT buttons to select
4. Use the DATA WHEEL to select the preset number you want to dump.
5. Press the STORE button. The Display will read
6. Press the STORE button again. The display will read
is complete at which time the display returns to
7. When finished, press EXIT.
NOTE: MIDI Preset Dump sends information on the MIDI channel defined in the
MIDI Channel Menu.

User HyperModel

Amp Dump
TM
This operation performs a System Exclusive (SysEx) User Hypermodel
Dump that uploads the GNX3000 Amp HyperModels to a SysEx librarian or MIDI
recording device. This is useful for making a backup copy of your customized Amp
HyperModels. The procedure for performing a User Amp Dump is as follows:
1. Connect a USB cable to your computer or a MIDI cable from the GNX3000
MIDI Out to the MIDI In of a MIDI recording device.
2. Press the UTILITY button. The Utility button's LED will light.
3. Use the PREV or NEXT buttons to select
4. Use the DATA WHEEL to select the Amp number you want to dump.
5. Press the STORE button. The display will read
6. Set the MIDI recording device to record.
7. Press the STORE button again. The display will read
is complete at which time the display returns to
8. When finished, press EXIT.
NOTE: Amp Dump sends information on the MIDI channel defined in the MIDI
Channel Menu.

MIDI Mapping

MIDI Mapping provides access to all factory and user presets from external MIDI
program change commands that may not correspond to the GNX3000 preset. This
is useful when multiple MIDI devices are chained together and controlled by one
central unit. For example, the main MIDI controller can send out a program change
command telling a particular MIDI unit to change to Program 10, but you may want
the GNX3000 to change to User Preset 27. You can remap the GNX3000 so when
it receives MIDI Program change 10, it calls up User Preset 27. The Procedure for
mapping MIDI program changes is as follows:
(Preset Dump).
PrSTDuMP
.
SeND TO
send pst
.
PrSTDuMP
(Amp Dump).
AMP DuMP
.
SND TO
send amp
.
AMP DuMP
GNX3000 Owner' s Manual
until the dump
Amp
TM
until the dump
121
GNX3000 Owner' s Manual