Expression Pedal Calibration; Bank Names - DigiTech GNX3000 Owner's Manual

Expression Pedal Calibration

The EXPRESSION PEDAL on the GNX3000 needs to be recalibrated for use after
a factory reset has been performed. This calibration procedure is automatically
activated after a factory reset procedure. In the event the pedal's calibration fails,
or if the pedal does not function properly, it can be re-calibrated using the Pedal
Calibration menu. The procedure for calibrating the EXPRESSION PEDAL is as follows:
1. Press the UTILITY button. The button will light indicating you are in the Utility
menu.
2. Use the PREV or NEXT buttons to select
Calibration).
3. Press the flashing STORE button to enter the Pedal Calibration Menu. The
display will read
TOE DowN
4. Rock the EXPRESSION PEDAL all the way forward to the toe down position and
press the blinking FOOTSWITCH 3. The display changes to read
up).
5. Rock the EXPRESSION PEDAL all the way back to the toe up position and press
the blinking number FOOTSWITCH 4.
NOTE: If the Display shows
2 through 5 need to be repeated.
6. When finished, press EXIT.

Bank Names

The GNX3000 lets you customize the names of the 13 User Banks where the 65 User
Presets reside. Customized Bank names aids in quickly identifying the User Bank
containing the presets you may need for a particular song or set. The procedure for
naming the User Banks is as follows:
1. Press the UTILITY button. The button will light indicating you are in the Utility
menu.
2. Use the PREV or NEXT buttons to select
3. Use the DATA WHEEL to select the User Bank you want to rename. The Preset
Bank LEDs to the left of the DATA WHEEL indicate when a User Bank is
selected.
4. Press STORE to access the Naming menu. The far left character of the Bank
name begins to blink.
5. Use the DATA WHEEL to select the desired alpha-numeric character.
6. Press the NEXT button to select the next character to the right, and the PREV
button to select the previous character to the left.
7. Repeat steps 5 and 6 until the Bank name appears in the display.
8. Once the Bank name appears correctly in the display, press STORE again.
9. When finished, press EXIT.
See page 133 for a list of Banks and Presets.
pedalcal
(Toe Down).
, a calibration error has occurred and steps
cal eRR
bankname
(Expression Pedal
(toe
TOE UP
(Bank Names).
119
GNX3000 Owner' s Manual
GNX3000 Owner' s Manual