DigiTech GNX3000 Owner's Manual page 57

3. Use the NEXT button to move to the next character (to the right), or the PREV
button to select the previous character (to the left).
4. Repeat steps 2 and 3 you have finished naming the new HyperModel
5. Press the AMP SAVE button again to select one of the 9 User HyperModel
locations. If all HyperModel locations in the GNX3000 are available, the
display will read U1 . The
location for storing a HyperModel. If one or more HyperModels have already
been stored, the number displayed will be the first empty HyperModel location.
If all 9 HyperModel locations are full, the GNX3000 defaults to the first
HyperModel location and displays
in the first location.
6. Use the DATA WHEEL to select a User location to save the HyperModel. If all
locations have been used, the display shows the name of the HyperModel about
to be overwritten.
7. Press the AMP SAVE button again to complete the Amp Save procedure. Press
the EXIT button at any time during the Amp Save procedure to abort the
process.
NOTE: The Amp Save procedure only saves Amp/Cabinet combinations to the User
HyperModel locations. It does not store changes or the new HyperModel to the
selected preset. See page 92 for information on storing changes to a preset.
U1 flashes, indicating that this is the first available
and the name of the HyperModel stored
U1
GNX3000 Owner' s Manual
.
TM
49
GNX3000 Owner' s Manual