Control Panel And Recording Setup - DigiTech GNX3000 Owner's Manual

Computer Recording via USB
GNX3000 Owner' s Manual
5. Click the OK button when the window stating changes will be saved upon re-
start appears.
6. Close the Pro Tracks Plus application. When you are prompted to save
changes, click No.
7. Re-start the Pro Tracks Plus application again.
8. Close the Tip of the Day and Quick Start windows if they appear.
9. From the Pro Tracks Plus menu bar, select Options>Audio.
10. Verify that the Playback and Record Timing Master settings have DigiTech
USB 1-2 In/Out selected. If not, select these now.
11. Click the Wave Profiler button at the bottom.
12. Click the Yes button to continue performing the tests.
13. When the profiling operation is successfully completed, click the OK button.
14. Click the OK button to close the Audio Options window if it is still open.
You are now ready to use the GNX3000 with Pro Tracks Plus
software.
CAUTION: Do not disconnect power or disconnect the USB cable from the
GNX3000 or the computer while the Pro Tracks Plus software is running. Doing so
can result in unpredictable behavior from your computer's operating system.

Control Panel and Recording Setup

The CONTROL PANEL is where the routing of all audio signals, both internal and
those connected to the GNX3000's audio inputs, are handled for both processing and
recording. Here is where you can route audio from the MIC and LINE INPUTS through
the GNX3000 effects as well as specify what signals are sent up USB to be recorded.
SHIFT
When this button is lit, the secondary functions labeled below specific buttons are now
active when these buttons are pressed.
USB 1-2 SOURCE
Selects what Input Sources are to be recorded up the USB 1-2 channels.
110
recording
TM