3Com SECPATH U200-CS Installation Manual page 15

Attribute
Services
3) Console cable
The console cable is an 8-core shielded cable. The RJ-45 connector at one end of the cable is for the
console port on the UTM device, and the DB-9 female connector at the other end is for the serial port on
a configuration terminal.
Figure 1-10 illustrates the console cable.
Figure 1-10 Console cable
Table 1-9 Console cable pinouts
RJ-45
1
2
3
4
5
6
7
8
For how to connect the console cable, refer to the "Connecting the Console Cable" section in Chapter 4
"Installing the U200 Series Device."
Ethernet interfaces
1) Introduction
A UTM series device provides fixed 10/100/1000Base-T Ethernet interfaces on its front panel, the
number of which depends on the device model. Each fixed Ethernet interface (RJ-45) uses two built-in
Connection to an ASCII terminal
Connection to the serial interface of a local PC to run the
terminal emulation program
Command line interface
Signal direction
—
1-9
Description
DB9
8
6
2
1
5
3
4
7
Signal
CTS
DSR
RXD
DCD
GND
TXD
DTR
RTS