Displaying And Maintaining Ipv6 Multicast Vlan; Ipv6 Multicast Vlan Configuration Examples; Sub-Vlan-Based Multicast Vlan Configuration Example - H3C LS-3100-52P-OVS-H3 Operation Manual

Configure IPv6 multicast VLAN ports in terface view or port group view
Follow these steps to configure IPv6 multicast VLAN ports in port view or port group view:
To do...
Enter system view
Configure the specified
VLAN as an IPv6 multicast
VLAN and enter IPv6
multicast VLAN view
Return to system view
Enter port view or port
group view
Configure the port(s) as
port(s) of the IPv6 muticast
VLAN
You cannot configure IPv6 multicast VLAN on a device with multicast routing enabled.
The VLAN to be configured as an IPv6 multicast VLAN must exist.
A port can belong to only one IPv6 multicast VLAN.

Displaying and Maintaining IPv6 Multicast VLAN

To do...
Display information about an
IPv6 multicast VLAN

IPv6 Multicast VLAN Configuration Examples

Sub-VLAN-Based Multicast VLAN Configuration Example

Network requirements
As shown in
1/0/1 and to Switch A, through GigabitEthernet 1/0/2.
MLDv1 is required on Router A, and MLD Snooping is required on Switch A. Router A is the MLD
querier.
Switch A's GigabitEthernet 1/0/1 belongs to VLAN 10, GigabitEthernet 1/0/2 through
GigabitEthernet 1/0/4 belong to VLAN 2 through VLAN 4 respectively, and Host A through Host C
are attached to GigabitEthernet 1/0/2 through GigabitEthernet 1/0/4 of Switch A.
Use this command...
system-view
multicast-vlan ipv6 vlan-id
quit
interface interface-type
interface-number
port-group manual port-group-name
port multicast-vlan ipv6 vlan-id
Use the command...
display multicast-vlan ipv6
[ vlan-id ]
Figure 1-4, Router A connects to an IPv6 multicast source through GigabitEthernet
Available in any view
1-6
Remarks
—
Required
Not an IPv6 multicast
VLAN by default.
—
Required
Use either command.
Required
By default, a user port
does not belong to any
IPv6 multicast VLAN.
Remarks