H3C LS-3100-52P-OVS-H3 Operation Manual page 1183

Figure 1-10 Network diagram for IPv6 PIM-SSM configuration
Vlan-int300
Source
Switch D
4001::100/64
Device Interface
Switch A Vlan-int100
Vlan-int101
Vlan-int102
Switch B Vlan-int200
Vlan-int103
Switch C Vlan-int200
Vlan-int104
Configuration procedure
1) Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing
Enable IPv6 forwarding on each switch and configure the IPv6 address and prefix length for each
interface as per Figure
Configure OSPFv3 for interoperation among the switches in the IPv6 PIM-SM domain. Ensure the
network-layer interoperation in the IPv6 PIM-SM domain and enable dynamic update of routing
information among the switches through an IPv6 unicast routing protocol. Detailed configuration steps
are omitted here.
2) Enable IPv6 multicast routing, and enable IPv6 PIM-SM and MLD
# Enable IPv6 multicast routing on Switch A, enable IPv6 PIM-SM on each interface, and run MLDv2 on
VLAN-interface 100, which connects Switch A to N1.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] mld version 2
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int105 Vlan-int103
Vlan-int105
Vlan-int104
Switch E
Vlan-int104
Vlan-int200
IPv6 PIM-SM
Switch C
IP address
1001::1/64
1002::1/64
1003::1/64
2001::1/64
2002::1/64
2001::2/64
3001::1/64
1-10. Detailed configuration steps are omitted here.
1-43
Vlan-int200
Vlan-int103
Switch B
Device Interface
Switch D Vlan-int300
Vlan-int101
Vlan-int105
Switch E Vlan-int104
Vlan-int103
Vlan-int102
Vlan-int105
Receiver
Host A
Host B
Receiver
Host C
Host D
IP address
4001::1/64
1002::2/64
4002::1/64
3001::2/64
2002::2/64
1003::2/64
4002::2/64