H3C LS-3100-52P-OVS-H3 Operation Manual page 1430

NeedToKnow mode is disabled
Intrusion Protection mode is NoAction
Max MAC address number is not configured
Stored MAC address number is 0
Authorization is permitted
After an 802.1X user gets online, you can see that the number of secure MAC addresses stored is 1.
You can also use the following command to view information about 802.1X users:
<Switch> display dot1x interface gigabitethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
EAD quick deploy is disabled
Configuration: Transmit Period
Quiet Period
Supp Timeout
The maximal retransmitting times
EAD quick deploy configuration:
EAD timeout:
The maximum 802.1X user resource number is 1024 per slot
Total current used 802.1X resource number is 1
GigabitEthernet1/0/1
802.1X protocol is enabled
Handshake is enabled
The port is an authenticator
Authentication Mode is Auto
Port Control Type is Mac-based
Guest VLAN: 0
Max number of on-line users is 256
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
EAP Response/Challenge Packets: 6
Error Packets: 0
1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
In addition, the port allows an additional user whose MAC address has an OUI among the specified
OUIs to access the port. You can use the following command to view the related information:
<Switch> display mac-address interface gigabitethernet 1/0/1
MAC ADDR VLAN ID
30 s, Handshake Period
60 s, Quiet Period Timer is disabled
30 s, Server Timeout
30m
is link-up
STATE PORT INDEX
1-16
15 s
100 s
2
AGING TIME(s)