Upgrading Pse Processing Software Online; Configuring The Poe Monitoring Function; Configuring A Power Alarm Threshold For The Pse - H3C LS-3100-52P-OVS-H3 Operation Manual

To do...
Configure a PD power management
priority policy

Configuring the PoE Monitoring Function

The PoE monitoring function involves monitoring of PoE power, PSE and PD.
Monitoring PoE power means monitoring the voltage of the PoE power.
When the current power utilization of the PSE is above or below the alarm threshold for the first
time, the system will send a Trap message.
When the PSE starts or stops supplying power to a PD, the system will send a Trap message, too.

Configuring a Power Alarm Threshold for the PSE

To do...
Enter system view
Configure a power alarm
threshold for the PSE

Upgrading PSE Processing Software Online

You can upgrade the PSE processing software online in either of the following two modes:
refresh mode
This mode enables you to update the PSE processing software without deleting it.
full mode
This mode deletes the PSE processing software and reloads it. When the PSE processing software is
damaged (in this case, you can execute none of PoE commands successfully), you can upgrade the
PSE software processing software in full mode to restore the PSE function.
Online PSE processing software upgrade may be unexpectedly interrupted (for example, an error
results in device reboot). If you fail to upgrade the PSE processing software in full mode after reboot,
you can power off the device and restart it before upgrading it again. After upgrade, restart the device
manually to make the original PoE configurations take effect.
Use the command...
poe pd-policy priority
Use the command...
system-view
poe utilization-threshold
utilization-threshold-value pse pse-id
1-6
Remarks
Optional
By default, no PD
power management
priority policy is
configured.
Remarks
—
Optional
80% by default.