FUTABA 8UHPS Instruction Manual page 71

The Throttle Cut function provides you an easy way to stop the engine by simply flipping a
switch with the throttle stick at idle, which commands the throttle servo to move a prescribed
amount. The amount of movement is largest at idle and disappears at high throttle. Both
t he switch's location and activation direction may be chosen by the owner.
Setting up Throttle Cut Operations
Turn the TH-CUT function ON or OFF by pressing the
(+) key ("ON" or "OFF" displayed depending on switch
position). Turn off (INH) the function with the (-) key.
Throttle Offset Movement Value
(Range: 0 - 40%)
(Initial value: 0%)
Chosen
TH-CUT
Switch direction display
switch
(NULL, UP, DOWN)
THROTTLE CUT MOVEMENT
SETTING
Adjust the amount of throttle motion
with the (+)/(-) keys.
• If you're unhappy with what you've
set, you may return to the default
value by pressing the (+) and (-)
keys simultaneously.
THROTTLE OFFSET
ACTIVATION SWITCH
SELECTION
Select the desired switch
location with the (+)/(-) keys.
You may choose any of
switches A-H.
When you change switches,
the chosen on/off directions are
reset to NULL. if this is the
case, be sure to reset the
direction.
68
These keys are used to move
To TIMER
around in the TH-CUT menu
function
To SUBTRM function
Data input keys
SWITCH DIRECTION
Select the on and off switch
directions with the (+)/(-) keys.
UP": Switch's upper position turns on
throttle-cut
"DOWN": Switch's lower position
turns off the function.
"NULL": TH-CUT is deactivated
without regard to a switch direction.