FUTABA 8UHPS Instruction Manual page 36

The servo reverse function may be used when you need to change the direction that a
servo responds to a control stick motion. When you use this function, BE SURE
THAT YOUR CONTROL IS MOVING THE CORRECT DIRECTION. If you are
using Advance Menu functions, set correct travels in the REVERS menu first, before
setting up the Advance Menu.
Reversing Servos
Channel display NORM or REV
display indicates
travel setting
*The blinking item is what is
being set.
The parameter function includes a number of submenus that are used to input basic
model data settings. This is best understood by viewing the menu structure on p. 16.
"NEXT" indicates that there is
a group of submenus in the
PARA function .
Indicates NORM or REVERS throw
setting
1. Aileron setting
Select "NORM" or "REV" with the
(+)/(-) keys.
2. Repeat above procedure to reverse
channels 2-8 as necessary:
2 = Elevator
3 = Throttle
4 = Rudder
5 = Gyro
6 = Pitch
7 = CH7
8 = CH8
Use the (>)/(<) keys to move to
the other submenus within the
PARA function.
PARA includes five
functions:
• Data reset
• ATL
• Engine starter
• Model type
• Modulation.
33
These keys are used to
reverse channels 1-8 in
To PARA
this menu as needed.
function
To F/S function
Data input keys
To INVERT or SWASH
function
To REVERS
function