FUTABA 8UHPS Instruction Manual page 12

Charging jack
NOTE: If you need to remove or replace the transmitter battery, do not pull on its
wires to remove it. Instead, gently pull on the connector's plastic housing where it
plugs in to the transmitter.
The factory default functions activated by the switches and knobs for a Mode 2
transmitter are shown below. Note that some of the functions will not operate until
activated in the mixing menus. In general, functions for a Mode 1 transmitter
reverse the E and G switches.
Switch / Knob
Switch A Elevator Dual Rate
↓
= PMIX-1, 2 on
Switch B Rudder Dual Rate
Switch C CH 7
Switch D Aileron Dual Rate
Switch E Idle-up
Switch F Inverted/CH5
Switch G fwd = Throttle Hold
Switch H Trainer
CH6 knob Hovering Pitch
CH7 knob Hovering Throttle
CH8 knob CH8
Ni-Cd battery pack
HELI
Elevator Dual Rate
Rudder Dual Rate
↑
= ELE→FLP on
center/
↓
= Airbrake on
Aileron Dual Rate
↓
= PMIX-5 on
↓
= PMIX-1, -2, -3 on
Landing Gear
Snap Roll/Trainer
Flap
(Flap trim if FLPRON on)
Spoiler
(disabled if AI-DIF on)
CH8
RF module
To remove, press the tabs together
and gently pull rearwards.
To install, line up the connector pins with
the socket in the rear of the module and
gently snap into position.
Trainer function
/DSC function connector
Battery connector location
Battery cover
ACRO
↓
= Idle-down
9
GLID
Elevator Dual Rate
↓
= Butterfly on
Rudder Dual Rate
↑
= ELE→FLP on
↓
center/ = Idle-down
↓
= PMIX-5 on
Aileron Dual Rate
back = Speed
forward = Start (Launch)
↓
= PMIX-1, -2, -3 on
GLID1FLP:Gear
Trainer
GLID1FLP: Flap
(Flap trim if FLPRON on)
GLID2FLP: Camber
(Flap trim if FLP-AI off)
Spoiler
(disabled if AI-DIF on)
CH8