FUTABA 8UHPS Instruction Manual page 57

The gyro mixing function is used to adjust the gyro sensitivity from the transmitter.
Use this function by connecting the gyro sensitivity adjustment input connector to the
channel 5 output of the receiver. Switch H or switch G (idle-up switch) can be
selected, and each direction of the changeover switch can be adjusted.
Switch H: The UP and DOWN sides sensitivity can be adjusted.
Switch G: The NORM, IDL1, and IDL2 sensitivities can be adjusted.
Entering Gyro Sensitivity Values
1. Activate Gyro Mixing Function
Press the (+) key to activate the GYRO function.
( Use the (-) key to INHibit the mixer.)
Sensitivity amount
Range: 0 to 100%
Switch
(Initial value: 50%)
direction
display
Switch H: UP, DOWN
Switch G: NORM, IDL1,IDL2
The Governor mixing function is used to adjust the GV-1 (Governor) speed
settings (rS1, rS2, rS3) from the transmitter. Whether speed switching and governor
ON/OFF are switched using one switch or ON/OFF switching is performed using an
independent switch can also be selected. When speed setting control uses CH7 and an
ON/OFF switch is used, CH8 can also be used.
When speed and ON/OF are switched using one switch
(Setting example)
Governor Speed Switch Position
(Switch C or G)
rS1: OFF UP or NORM
rS2: 1400 CNTR or IDL1
rS3: 1700 DOWN or IDL2
* For instance, rS3 is adjusted by setting the maximum speed used and lowering it
from the transmitter.
* For the time being, use the initial rate setting above.
* Since speed adjustment from the transmitter is rate setting, for the actual speed,
checking the governor side display and remembering its relationship with the actual
speed is convenient.
When governor ON/OFF is controlled using switch B
When governor ON/OFF uses an independent switch, the speed can be adjusted and
switched using each position (3 points) of switch C or G.
2. "UP" side setting
Enter your desired sensitivity value
with the (+)/(-) keys.
3. "DOWN" side setting
Enter your desired sensitivity value
with the (+)/(-) keys.
4. Switch selection
Slect the desired switch with the
(+)/(-) keys.
Rate
(%)
0 Use up to 0% (Governor speed display: "off")
50 Speed adjusted by raising and lowering "50%" rate.
100 Speed adjusted by lowering "100%" rate.
54
These keys are used to move
To GOVrpm
around in the GYRO menu.
function
To HOV-PI
function
Adjustment from Transmitter
Data input keys