FUTABA 8UHPS Instruction Manual page 33

Setting Dual Rate Values and Switches
Channel display: AI = Aileron,
EL = Elevator, RU = Rudder
(The value of the stick adjusted
by stick operation blinks.)
Range: 30 - 140%.
Initial value=100%
Channel display
D/R switch display
(SW-A, SW-B, SW-D, SW-E for
helicopters, STK-1, STK-2,
STK-3, STK-4)
*The blinking item is what is
being set.
STK-1:Aileron stick
STK-2:Elevator stick
STK-3:Throttle stick
STK-4:Rudder stick
Indicates top or bottom
switch position (top shown)
1. Aileron adjustment: place the
aileron D/R switch and stick in the
direction you want to adjust and
set the rate with the (+)/(-) keys.
2. Elevator: place the elevator D/R
switch and stick in the direction
you want to set and adjust with
the (+)/(-) keys.
3. Rudder: put the rudder D/R
switch and stick in the direction
you want to adjust and set with
the (+)/(-) keys.
• If you're unhappy with your set
value, you may return to the default
value by pressing the (+) and (-)
keys simultaneously.
4. Select Aileron D/R switch
with the (+)/(-) keys.
5. Select the Elevator D/R
switch with the (+)/(-) keys.
6. Select the Rudder D/R
switch with the (+)/(-) keys.
You can put all three rates on a
single switch.
See notes to right about stick
switch setting.
(STK-1/STK-2/STK-4)
stick operation
(STK-3)
stick operation
30
These keys are used to move
To EXP
through items 1-6 in this menu.
function
To ATV function
You may wish to select "STK-x" when
you want to have the dual rate turn
on and off according to the position of
the stick. This is effective during
stall turns and other maneuvers.
After you have selected the "STK-x"
menu, hold the stick at the position
you wish to switch dual rates.
Next, store the position by pressing
the (+) and (-) keys simultaneously.
This will change the stick position
blinking numbers. Check that the
dual rate is switching by moving the
stick. The little arrow should move
from one side to the other.
100% 90% 0%
B rate A rate
0% 30%
B rate A rate
Data input keys
90%100%
B rate
100%