FUTABA 8UHPS Instruction Manual page 58

Caution:
The relationship of the governor speed setting rS1~rS3 and the switch positions
conforms to the table above. Since the governor mixing function may not be used or
the direction may be different, if this mixing was turned ON, first check the direction.
At throttle hold, always check that the governor is OFF. Conversely, when the
speed value rises, reverse it as described in "Throttle hold OFF direction selection".
Setting the Governor Mixing Function
1. Activate Governor Mixing Function
Press the (+) key to activate the GOVrpm function.
( Use the (-) key to INHibit the mixer.)
Speed setting
Range: 0 to 100%
Switch
(Initial value:
direction
UP=0%
display
CNTR=50%
DOWN=100%)
Channel setting
Range: CH7 or CH8
Current setting
Range: lmt+, lmt-
Switch display
Range: SW-C or SW-G
2. "UP" Side Rate Setting:
Enter your desired speed value
with the (+)/(-) keys.
3. "CNTR" :
Enter your desired speed value
with the (+)/(-) keys.
4. "DOWN":
Enter your desired speed value
with the (+)/(-) keys.
Switch C: UP, CNTR, DOWN
Switch G: NORM, IDL1,IDL2
5. ON/OFF Channel Selection
Select the output channel with
the (+)/(-) keys.
CH7: CH7 controls the speed and ON/OFF.
CH8: CH8 independently controls ON/OFF.
ON/OFF is performed with switch B.
6. Selection of OFF Direction at Throttle Hold
Operate the (+)/(-) keys in the direction that turns
the Governor off at throttle hold operation.
7. Switch Selection
Chose the desired mixer switch
with (+)/(-) keys.
55
These keys are used to move
To TH-NDL
around in the GOVrpm menu.
function
To GYRO
function
Data input keys