FUTABA 8UHPS Instruction Manual page 55

(Continued from preceding page)
Link function ON/OFF
indicator
Trim ON/OFF indicator
Displays offset position
Current Displays
on/off ON/OFF switch
switch direction
5. Link function setting
Turn the Link function ON or OFF
with the (+)/(-) keys. When the Link
function is ON, ">" is displayed
after the slave channel on the
screen.
6. Trim setting
This couples the master
channel's trim with the slave
function. Select ON/OFF with
the (+)/(-) keys.
7. Offsetting neutral mix point
If you want the mix to occur
somewhere besides master
neutral, hold the master
channel control in the desired
position, and store the offset
position by pressing the (+)/(-)
keys simultaneously.
8. Switch selection
Choose the desired mixer
ON/OFF switch with the (+)/(-)
keys.
9. ON/OFF Direction
Set the ON/OFF directions with
the (+)/(-) keys.
NULL = Normal operation regardless of switch setting
UP = Switch upper or rear position turns on the function
CNTR = Center position of 3-position switch turns on the function
DOWN = Switch lower or forward position turns on the function
52
These keys are used to move
To PMIX-2
around in the PMIX-1 menu
function
To TH-NDL
function
• If you select "STK-3" to turn mixer
on and off, you'll need to set the
switching position and direction. To
do so, first position the throttle stick
where you want switching to occur.
Next, enter the stick position into
memory by pressing the (+)/(-) keys
simultaneously. (a percentage will be
displayed on the screen.
If you want mixing turned on at the
high throttle side of the set position,
press the (+) key. If you want mixing
on at the low throttle side, press the
(-) key. An arrow is displayed above
or below the small "3" at the right top
corner of the screen to verify proper
switching direction.
When you think you're done, move
the throttle stick and check if
programmable mixing switches on
and off in accordance with your
settings.
Data input keys