FUTABA 8UHPS Instruction Manual page 44

The Trainer function is used to train novice pilots using an optional trainer cord connecting
two transmitters. The instructor may choose that all channels be controlled by the student, or
that certain designated channels be operated by the student and the remainder by the instructor.
Pulling on Switch F allows the student to control the selected channels on the model. You
may use your 8UH transmitter with any transmitter of the SKYSPORT, Super 7, or 1024Z
series of transmitters. Simply plug the optional trainer cord (sold separately) into the trainer
connection on each transmitter. Note that when the trainer function is active, the snap roll
function is automatically deactivated.
Trainer function operation modes:
"FUNC": When the trainer switch is ON, the channel set to this mode can be
controlled by the student by using the mixing set at the instructor's transmitter.
"OFF": The channel set to this mode cannot be controlled by the student even when
the trainer switch is ON. The set channel can be controlled by the instructor only.
"NORM": When the trainer switch is ON, the channel set to this mode can be
controlled by the student. The set channel is controlled according to the contents set at
the student's transmitter.
Examples:
When the stick channel is set to the "FUNC" mode, helicopter stick operation practice
is possible even with a 4VF transmitter (4 channels for aircraft).
The practice channel matched to the student level can be set to the "NORM" mode
and the other channels can be set to the "OFF" mode and controlled by the instructor.
A few important precautions:
• NEVER turn on the student transmitter power. Collapse the student's antenna.
• ALWAYS set the student transmitter modulation mode to PPM.
• BE SURE that the student and instructor transmitters have identical trim and control motions.
Verify by switching back and forth while moving the control sticks.
• FULLY extend the instructor's antenna.
• Always remove the student transmitter RF module (if it is a module-type transmitter).
Setting up Trainer mode
1. ACTivate the TRAINR function by pressing
the (+) key. (INH the function with the (-) key.)
Channel
Current setting display
display
(FUNC, OFF, NORM)
To TH-CUT function
This menu appears when turning
individual channels on and off
2. Aileron setting
Select "FUNC", "OFF", or "NORM"
with the (+)/(-) keys.
3. Elevator - Channel 8 are set
similarly.
41
These keys are used to move through channels
1-8 in this menu.
To SUBTRM function
Data input keys