FUTABA 12Z Series Instruction Manual page 74

Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also be
that the motion of a command channel, called the
"master," is added to the motion of the mixed channel,
called "slave."
You may choose to have the Master's trim added to
the Slave channel response ("Trim" setting). The mixing
curve can be changed so that the undesired tendencies
can be corrected effectively by setting the LINEAR1/
LINEAR2/EXP1/EXP2/VTR/LINE/SPLINE modes.
The Delay function can be programmed for each rate.
The Delay is used to change the rate smoothly when
switching mixes. You may define Mixing ON/OFF
switch, control or you may choose to have mixing
the setup screen shown below by pushing the
enter button.
[Return Key]
w h o s e f u n c t i o n y o u w a n t t o
activate and call the setup screen
by pushing the enter button.
*When the function is activated, the master
and slave channel name or "OFFS.MIX" is
displayed.
74 <Model Menu (Common Functions)>
be used for each condition. [All model types]
by turning the data input dial and change the
mode by pushing the enter button.
[MIXING]: Mixing from normal master CH to slave CH
[OFFSET]: Master CH not used
(Currently selected condition name)
(For a description of the setting method, see
the description at the back of this manual.)
remaining on all the time.
Offset-type mixing applies a fixed offset or preset
to the programmed channel servo operation and
may control up to four circuits simultaneously. The
Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with other
programmable mixing functions. The link function can
be set up for Master and Slave channel individually.
The slave channel AFR mode (STK-STK mode)
may be selected, where the slave channel AFR and
D/R settings are observed when Link function is set.
circuit. (Fine tune function)
PUSH
(For more information, see the description at the back of
this manual.)
Mixing mode change
[Cursor Lever]
[Data Input Dial]
[Enter Button]