FUTABA 12Z Series Instruction Manual page 70

The functions in the Model Menu can be used by
switching the settings of up to 8 flight conditions
conditions. Add conditions, as required.
When you do not want to use the Condition
Select function, this setting is unnecessary. In
this case, use the flight conditions (CONDIT1 or
NORMAL) assigned at initial setting.
addition to ordinary toggle switch, is possible
as the flight condition selector switch, this
call the setup screen shown below by pushing the
enter button.
[Return Key]
*Perform the settings below after using the cursor lever to
move the cursor to the item you want to set.
Condition addition
button.
*Only the No. of the conditions which can be added is
displayed.
2. Add the condition by pushing the enter
button again.
setup screen by pushing the enter button,
used in condition switching.
(For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.)
*The data (except the condition name) of the condition
currently being used is copied to the added condition.
70 <Model Menu (Common Functions)>
Flight condition's addition, deletion, copy, condition renaming, and
condition delay can be set. [All model types]
(Conditions List)
when there are sudden changes in the servo
positions and when there are variations in
the operating time between channels during
condition switching can be suppressed. The
delay can be set for each channel.
When setting the delay function at the
s w i t c h i n g d e s t i n a t i o n c o n d i t i o n , t h e
related function changes after a delay
corresponding to the set amount.
operation priority can be freely changed.
selected condition name is displayed on
the screen. When a condition has been
added, give it a name which can be easily
(Currently selected condition name)
PUSH
Condition deletion
the condition you want to delete in the
conditions list.
*The number before the condition name starts to blink to
show that it is to be deleted.
2. After once operating the cursor lever to the
and push the enter button.
*Note that if initially operated up and down, the objective
condition changes.
3. When the enter button is pushed again, the
to stop deletion.)
Condition name change
the condition you want to change in the
conditions list.
2. After once operating the cursor lever to the
left or right, move the cursor to [RENAME]
*The condition name setup screen appears.
[Cursor Lever]
[Data Input Dial]
[Enter Button]