Adjusting The Lcd Monitor - Wacom CINTIQ 17SX Installation Manual And User's Manual

ADJUSTING THE LCD MONITOR

FACTORY PRESETS, MULTI-SYNC, AND USER SETTINGS
Factory Presets: To display images with the best quality (based on the incoming signal), the DTU-710
comes with a number of factory default standard display modes. Refer to page 42 for input signal
specifications.
Multi-Sync: When connected as a VGA display, the DTU-710 attempts to automatically synchronize to
the incoming signal. Multi-sync will function when the horizontal frequency is between 30 to 80 kHz and
the vertical frequency is between 50 to 75 Hz. If the DTU-710 does not automatically synchronize with
the incoming signal, you can use the On Screen Display (OSD) R
display synchronization. Further screen display adjustments can be manually made using the OSD
controls.
User Settings: When you manually set the display using the OSD function, the settings are stored
within the DTU-710 for use the next time the unit receives a similar signal. This is applicable to all
display modes.
WORKING WITH ON SCREEN DISPLAY SETTINGS
The DTU-710 is equipped with an On Screen Display (OSD) function. The OSD function enables you
to adjust and optimize a variety of display settings at the touch of a button. The OSD controls are
located at the front of the unit.
Menu Button
Opens or closes the OSD menu.
The basic process for working with the OSD is as follows:
• Press the M button to open the OSD main menu.
ENU
• Use the + or – buttons to select an option. When the option you want to adjust is highlighted, press
the E button. The current settings and adjustment sub-menu for that option will appear.
NTER
• Use the + or – buttons to adjust the option settings.
• After making your changes, press the E
Note: All settings are automatically saved when the OSD menu closes. If you make changes to
the display appearance and cannot return to the original settings, use the R
to return the DTU-710 to its original factory defaults.
–
Selection Buttons
Use these buttons to select an option that can be activated when you press the
E button. After activating a selected option, press the + button to increase a
NTER
selected item value, and press the – button to decrease it.
NTER
ESET
+
button to save. To exit, press the M
A A option to initiate
UTO DJUST
E Button
NTER
Activates or deactivates the
selected OSD menu option.
button.
ENU
R
ESET ECALL
CUSTOMIZING
option
Page 23