Adjusting The Lcd Monitor; Factory Presets, Auto Adjust And User Settings; Functions And Uses Of The Menu Window - Wacom Cintiq 15X Manual

Adjusting the LCD Monitor

Factory Presets, Auto Adjust and User Settings

Factory Presets: The Cintiq 15X is programmed with some prevailing display modes as defaults so that the
Cintiq 15X can display the image with the bast quality based on the incoming signals for most cases.
Auto Adjust: When the Cintiq 15X first receives the signals with a display mode out of factory presets, the
Auto Adjust automatically adjusts horizontal/vertical position, phase and pitch if horizontal frequency is be-
tween 28 to 64 kHz and vertical frequency is between 48 to 75 Hz. The adjusted settings will be stored in the
Cintiq 15X to display in the best condition when the same signals are received next time. This is effective for
analog RGB only. While the Auto Adjust is working, except for the power switch, all buttons will not work.
User Settings: For any display modes, once you manually set the display by using the MENU window, the
settings will be stored in the Cintiq 15X to display in the same condition when the Cintiq 15X receives the
same signals next time.

Functions and Uses of the MENU Window

To open the MENU Window: Press the MENU button ' '.
To switch an item: Press the + (plus) button ' ' or the - (minus) button ' ' .
To change setting in the item: Press the ENTER button ' ' to activate the item, then press the + (plus) button
' ', - (minus) button ' ' and/or ENTER button ' '.
To exit the MENU Window: Press the MENU button ' '.
Contrast
Adjusts contrast.
Brightness
Adjusts black level.
16
CONTRAST
BRIGHTNESS
Phase
(Analog RGB only)
Calibrates phase when the
Auto Adjust is not
enough. P18
Pitch
(Analog RGB only)
Calibrates pitch when the
Auto Adjust is not enough.
P18