Cisco 7935 - IP Conference Station VoIP Phone Administration Manual page 40

Installing the Cisco IP Conference Station 7935
1
Power outlet in the wall
2
Power supply unit
3 Power supply unit power cord
4
PIM
5
LAN connection
Step 1
Step 2
Step 3
Step 4
Note
Cisco IP Conference Station 7935 Administration Guide
2-12
To install an IP Conference Station, perform the following steps:
Place the IP Conference Station on a flat surface, for example, a conference room
table or desktop.
Connect one end of the 6 ft. CAT 5 cable to your data network port and connect
the other end to the network (LAN) port on the PIM.
Connect the free end of the 25 ft. CAT 5 cable to the RJ-45 port on the bottom of
the IP Conference Station. (The cable is pre-plugged into the PIM.)
Connect the power supply unit to the AC adapter port on the PIM, and plug the
other end into a standard electrical power outlet in the wall.
If you do not correctly connect the cables, PIM, power supply, and the
IP Conference Station unit, the IP Conference Station will not work. Use of
non-Cisco certified components may not work and may void the
IP Conference Station product warranty.
Chapter 2 Installation of the Cisco IP Conference Station 7935
6
RJ-45 port on the bottom of the
IP Conference Station
7
Free end of the 25 ft. CAT 5 cable
8 LAN connection on PIM
9
25 ft. CAT 5 cable connection on PIM
10 AC adapter port on PIM for power supply unit
78-12727-03