Assigning A Subnet Mask - Cisco 7935 - IP Conference Station VoIP Phone Administration Manual

Accessing Network Configuration Settings
Step 1
Step 2
Step 3
Step 4

Assigning a Subnet Mask

Note
Step 1
Step 2
Step 3
Step 4
Cisco IP Conference Station 7935 Administration Guide
3-8
Each IP address has two parts: the network ID and the host ID. The network ID
identifies all hosts that are on the same physical network. The host ID identifies a
specific host on a network.
Follow these steps to assign an IP address.
Press the Up or Down scroll button to select IP address.
The current IP address is displayed.
Use the < softkey to delete the current IP address.
Use the dialing pad to enter a new IP address.
Use the . softkey to enter periods (.) and the < softkey to correct any mistakes.
Press the Save softkey to save your changes.
You can only manually assign a subnet mask if DHCP is disabled.
The subnet mask is used to partition the IP address into a network and a host
identifier. The subnet mask is used to mask a portion of the IP address so that
TCP/IP can distinguish the network ID from the host ID.
Follow these steps to assign a subnet mask.
Press the Up or Down scroll button to select IP Mask.
Use the < softkey to delete the current subnet mask.
Use the dialing pad to enter a new subnet mask.
Use the . softkey to enter periods (.) and the < softkey to correct any mistakes.
Press the Save softkey to save your changes.
Chapter 3 Configuration of the Cisco IP Conference Station 7935
78-12727-03