Safety Notices - Cisco 7935 - IP Conference Station VoIP Phone Administration Manual

Chapter 2 Installation of the Cisco IP Conference Station 7935

Safety Notices

Warning
Warning
Warning
Warning
Warning
Warning
78-12727-03
These are the safety considerations for using the IP Conference Station. Read
these notices before you install or use the IP Conference Station. You can also
refer to the Regulatory Compliance and Safety Information for the Cisco IP
Conference Station 7935 for international agency compliance, safety, and
statutory information for the Cisco IP Conference Station 7935.
Read the installation instructions before you connect the system to its power
source.
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
To avoid electric shock, do not connect safety extra low voltage (SELV) circuits
to telephone network voltage (TNV) circuits. LAN ports contain SELV circuits,
and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45
connectors. Use caution when connecting cables.
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15 A U.S.
(240 VAC, 10 A international) is used on the phase conductors (all
current-carrying conductors).
Installing the Cisco IP Conference Station 7935
Cisco IP Conference Station 7935 Administration Guide
2-9