Table of Contents
Advertisement
Bicycle carrier*
Install cross member
– Remove the rear seats or fold the seats fully forwards, in order to make
available the necessary space in the luggage compartment
⇒ page 68.
A
– Release the fixtures
pulling up the securing screws
– Position the cross member with the fixed (not pulled out) part onto
the (in direction of travel) right lashing eye and then the pull-out part
A
onto the left lashing eye.
A
A
– Secure the fixture
B
place.
– Tighten the fixing screws
– Check the attachment of the cross member by pulling it.
Using the system
Safety
Fig. 89 Install cross member
at the ends of the cross member by slightly
B
A
.
C
to both sides and lock the fixing screws
A
up to the stop.
C
Driving Tips
WARNING
When transporting the bicycles in the luggage compartment, ensure the
safety of the passengers transported on the rear seats ⇒ page 130, "Correct
seated position for the occupants on the rear seats".
Install bicycle carrier
– Position the approved bicycle carrier on the cross member, after
pulling up the screw
cross member and screw the screw
– Slacken the screw
pull out, then position the moveable part of the carrier, depending on
A
in
C
bicycle size, into one of the three possible positions.
– Insert the screw
General Maintenance
Breakdown assistance
Seats and Storage
Fig. 90 Install bicycle carrier
A
push the frame side rail (alu-part) towards the
A
A
into the nut
A
A
on the moveable part of the bicycle carrier and
B
A
into the desired position and tighten.
B
Praktik
77
⇒ fig.
90.
Technical Data
Advertisement
Table of Contents
